High pressure dosing pumps are useful in many occasions of technology, and high pressure and mass flow are the typical features of it. However, high pressure is also the test of the high pressure dosing pump itself so you must pay attention to the following five areas when using it.
Attention Points In The Process Of Using High Pressure Dosing Pumps
Avoid starting it in low pressure
In order to improve the efficiency of the high pressure dosing pump, you should choose the correct nozzle. High pressure dosing pumps have replaceable nozzles, which can be used for many purposes. Proper selection will make the process of nozzle cleaning more efficient.
When installing high pressure dosing pumps, the cables should be wires, and the power cord shouldn’t be too long.
In order to avoid breaking the cable, please don’t force the cable when the unit is launched. High pressure dosing pumps don’t sink mud, otherwise, it will lead to poor heat dissipation and the burning of motor winding.
Please focus on the model, flow, and head when purchasing high pressure dosing pumps.
If you choose an inappropriate model, it won’t get adequate water, and the efficiency of the unit won’t work. To prevent the leakage of high pressure dosing pumps in electric shock accidents, the earth leaking circuit breaker should be installed.
High pressure dosing pumps shouldn’t operate for a long time and shouldn’t draw plenty of sand water.
Be careful when painting the windows, vents, eaves, and walls, because the high water pressure will knock down fixed windows or break them. When the wall is clean, the water cannon should point to the lower part of the wall to reduce the spraying force, which will prevent water from falling. Additionally, be careful when cleaning the outer walls. Water can penetrate the holes in the edges of windows so check all windows’ frames to prevent penetration.
The motor of High pressure dosing pumps should be checked regularly.
In order to avoid water seeping into the high pressure dosing pumps, you should replace or repair them in time if you find cracks or rubber seal’s damage or failure.
The High pressure dosing pump of NEWDOSE uses quality modified PTFE diaphragms, and the maximum pressure is up to 3MPa, which significantly improves the head of the dosing pump and can be used as the institute to some conditions of hydraulic diaphragm pumps.
Ark Electric & Mechanical Co., Ltd (ARK LTD) is one of professional diaphragm metering pump manufacturers. We provide Solenoid Dosing Pump, Motor Driven Diaphragm Pump, metered dose pump, high pressure metering pump and so on. Want to know more? Please contact us.
